PCS Rigid foam underlay, Square drain wetroom kit for Tiling inc tanking & drain
15 Sizes of foam cored wetroom formers ready to fit on to a boarded floor. Complete with tanking compound and dallmer horizontal drain outlet. (Vertical outlet available on request - same price).
For tiling only. Wetroom floor former for perfect falls to the drain. Under boarding required for spanning joists. Most sizes 20mm thick at the edges. (see sizes below for exceptions) Easy to cut and trim on site to exact dimensions.
Drain hole former ready fitted Dallmer Drain with square grid, designer grid options available. Standard drain projection beneath tray = 86.5mm Optional vertical outlet drain. Supplied with full tanking kit for the most reliable waterproof sealing.
See below for sizes available
Why our Foam Cored underlay is so special We insist on extruded foam (not styrene balls)
Why density is important. Our Underlay Wetfloors and Tile Backer Boards are made from extruded foam (not agglomerated styrene particles). As a result the density weight loading is 30 tons per sq. metre. This may sound a lot, but gives us the confidence to permit use of tiny (25mm x 25mm) mosaic tiling. The maximum point load per tile is therefore 18.7Kg per 25mm x 25mm tile and customers can have total peace of mind that the tile will not sink into the underlay.
Note: Beware of competitor products with densities of 12 - 24 tons per sq. metre.
Extra Tough Skin Each side of the former is layered with a reinforcing mesh and covered in a continuous layer of polymer cement.
PCS Kits c/w Dallmer Drains The Dallmer drain is specially designed for quick installation under the wetroom former. When the former is fitted the trap is pulled up tight and sealed to the ready fitted hole former.
High flow of water - 32 litres/minute. Supplied complete with pipe reducer to 1 1/2 inch
Horizontal outlet or chose vertical outlet. Standard grate supplied with kit. Optional 316 grade stainless steel polished designer grids available. (If you require an upgrade price on any of the grids below, Please email for price. Above Square Stainless grid supplied as standard
PCS Square drain wetroom kit contents:
1 - Underlay for level access (requires under-boarding support).
1 - Dallmer drain c/w stainless grid. Horizontal or Vertical outlet (please specify).
1 - Pipe reducer 2" to 11⁄2" (50mm to 40mm).
1 - 8k tanking liquid (covers 10m2).
1 - 1 Litre Primer for porous surfaces.
1 - 10m Tape for wall/floor joint and other gaps.
2 - Internal corners.
2 - Pipe collars.
1 - 75mm brush.
Note: The PCS wetroom kit is not suitable for use with vinyl flooring.
But unlike competitor kits it can be used with 25mm square mosaic tiles.